“Hey Guys, welcome to my first Instructables article. So guys today we are going to make a ” Table Edge Avoiding Robot “.
Let me first tell you about the main working principle of this robot:
This car uses a very working principle that is as follows: ~ When the car reaches the end of the table i.e. the edge of the table the ultrasonic sensor detects the depth of it and it makes the car go back.
If you have not understood its working principle then take a look at the whole tutorial you might then understand it…
So let’s get started with the project :-)
Supplies:
- Arduino Uno
- L298D Motor Driver
- Bluetooth Module
- UltraSonic Sensor
- Gear Motor
- Rubber Wheel
- Battery Holder
- Battery”