“KAUDA is a printable and DIY robotic arm developed with the aim of creating a robot that could cover the functions you want at a low cost, without losing quality and efficiency.
Developed by a maker for makers, for those who want to work on it, apply changes, study new functions and therefore have fun with it.
KAUDA is intended primarily for students, teachers, schools and universities, in order to be able to work with simple and intuitive robots, easy to make, assemble and program.
In a short time you can have a simple, intuitive and fun product on your desk, teaching post or work station.
3D Printed Parts:
Base [QTTY. 1]
Base door [QTTY. 2]
Internal GW [QTTY. 1]
Base ring [QTTY. 1]
Axis 1 [QTTY. 1]
Axis 2 [QTTY. 1]
GW Axis 2 [QTTY. 2]
GW Base [QTTY. 1]
GW Axis 1 [QTTY. 3]
Axis 3 [QTTY. 1]
GW Axis 4 [QTTY. 1]
Axis 4 [QTTY. 1]
Rot dwn Axis 4 [QTTY. 1]
Rot up Axis 4 [QTTY. 1]
Axis 5 [QTTY. 1]
GR Pz1 [QTTY. 3]
GR Pz2 [QTTY. 6]
GR Pz3 [QTTY. 6]
GR Pz4 [QTTY. 3]
GR Pz5 [QTTY. 1]
GR Pz6 [QTTY. 3]
3D Printed Parts (optional):
Axis 1 Dec1 [QTTY. 2]
Axis 1 Dec2 [QTTY. 1]
Axis 1 Dec3 [QTTY. 1]
Axis 3 Dec1 [QTTY. 1]
Axis 3 Dec2 [QTTY. 1]
Axis 3 Dec3 [QTTY. 1]
Axis 3 Dec4 [QTTY. 1]
Axis 4 Dec [QTTY. 1]
Hardware Parts:
Steel rod Ø8 x 80 [QTTY. 2]
Steel balls Ø8 [QTTY. 40]
Steel Rod 3 mm [QTTY. 18]
Round aluminum tube Ø 35 x 90 [QTTY. 1]
Round aluminum tube Ø 40 x 110 [QTTY. 1]
Steel rod Ø8 x 15 [QTTY. 1]
M3 nut
M3 x 12 SHCS screw
M3 x 20 SHCS screw
M3 x 12 SHCS screw
Bearings Ø22 x 7 mm [QTTY. 5]
Electronics:
Nema 17 Stepper-M [QTTY. 4]
G16 - 8 Pin [QTTY. 2]
G20 - 12 Pin [QTTY. 1]
DC 6V Extended Gear Motor with Shaft [QTTY. 1]
Nema 17 Cables [QTTY. 4]
MG996R Servo-M [QTTY. 2]”