Content for TPIC6B595

TPIC6B595

The TPIC6B595 device is a monolithic, high-voltage, medium-current power 8-bit shift register designed for use in systems that require relatively high load power. The device contains a built-in voltage clamp on the outputs for inductive transient protection. Power driver applications include relays, solenoids, and other medium current or high-voltage loads. This device contains an 8-bit serial-in, parallel-out shift register that feeds an 8-bit D-type storage register. Data transfers through the shift and storage registers on the rising edge of the shift-register clock (SRCK) and the register clock (RCK), respectively. The storage register transfers data to the output buffer when shift-register clear (SRCLR) is high. When SRCLR is low, the input shift register is cleared. When output enable (G) is held high, all data in the output buffers is held low and all drain outputs are off. When G is held low, data from the storage register is transparent to the output buffers. When data in the output buffers is low, the DMOS-transistor outputs are off. When data is high, the DMOS transistor outputs have sink-current capability. The serial output (SER OUT) allows for cascading of the data from the shift register to additional devices.

ATtiny85 - Spectrum Analyzer on RGB Led Matrix 16x20

“Continuing with ATtiny85, today I’d like to share how to build a music spectrum analyzer on 16x20 RGB led matrix. The music signal FFT transformation and LED Bit Angle Modulation are all carried out by one DigiSpark ATtiny85. Main …

Rainbow Led Circuit Sculpture

“Today I would like to share how to make a sculpture circuit that controls 16 RGB leds using ATTINY85. We can adjust their colors separately according to the colorwheel rule with a touch button. The main components are as follows …

Attiny85 Simultaneously Using I2C And Spi Protocols

“The Attiny85 does not support specific hardware for SPI and I2C comunications as on ATmega series, instead there is a hardware module called UNIVERSAL SERIAL INTERFACE (USI) that can be only configured to perform SPI or I2C. In this small …

ESP-01 CONTROL RGB LED CUBE 4x4x4

“ESP-01 ESP8266 can be used as a stand-alone device to control a RGB led cube 4x4x4. Today, I’d like to share how ESP-01 ESP8266 can be used as a stand-alone device to control a RGB led cube …

RGB LED CUBE 4x4x4

“Today I’ll share how to make an 4x4x4 led cube which is built from Arduino Nano, RGB LEDs 10mm - common anode and double side prototype PCB. Let get started. Main parts include: 01pcs x Arduino NANO. 64pcs x RGB …

Bottle Binary Clock

“In this Instructable, I’d like to show how to make a simple Bottle Binary Clock. This binary clock can read time information from an NTP server and clock will be updated over WIFI. Time will be shown by RGB …

Multi-Effects Internet Clock

“I have six red matrix LEDs in my warehouse, it seemed I bought them when I was a student about 15 years ago. It’s surprising that theyre still in good condition. Today I’d like to share how to …

What is an ETA Nixie Tube Clock and How Do You Build One?

“In our house, the concept of time is somewhat fuzzy. This is especially true in the morning as we get ready for school and work. The amount of days dropping off the kids late to school is a little embarrassing …