Other
“A 4-legged mobile robot that tracks and wiggles its tail when it sees a human face. It can be controlled from remote PC through WiFi. The development of terrestrial locomotion of legged robots has been continuously growing over the past …
“A CO2, temperature and humidity meter using ESP32 and Bytebeam cloud for indoor air quality analysis and monitoring. ndoor air quality (IAQ) monitoring is a very often talked about topic nowadays as it critically affects a person’s health, comfort …
“After around 18 months of using my previous mail notifier the mobile network provider that I was using, ASDA, decided to move from EE’s network to Vodafone’s network. Unfortunately, the A9G GPRS module doesn’t like the Vodafone …
“With the development of cryptanalysis and new hacking techniques, the cost of accessing your data without your authorization continues to decline, making it easier and more attractive for different sides to get it. I’m not going to get into …
“Modifying code example for ESP32 WiFi Scanner to display on OLED instead of Serial Monitor The codes generated from this project is by modifying code of others (The reference link is attached below). It comes to my mind when I …
“DIY Laser Scanning Microscope made from a defective Blu-Ray Player. A Blu-ray player must be able to detect the microscopically tiny pits on DVDs in order to play back a film. Therefore, the question arises: Can a Blu-ray player also …
“This is my remake of Mirko Pavleski’s Universal VFO 10 KHz-160 MHz with Retro Analog Scale project. The Si5351 Clock Generator has three independent outputs. Each one can have a different frequency. Part of this redesign is to make …
“Measuring time using rhythms, pulses and gravity with an animated 32x32 RGB LED matrix The Circle of Life Entropy dictates that all ordered structures will eventually collapse. This includes the collapse of life. Hope, then, hangs on the cycles of …
“BLE relay device for Home Assistant that, for the most of time is in a very low energy state and only a few seconds per minute is awake. The purpose of this project, was to develope a BLE relay device …
“In this project we will be creating an RC Car from scratch using 3D printed parts! Which will be used in my next project where we will be making the RC Car fully autonomous, that can drive itself, detect signs …