Other
“This repository describes an idea of easy hack (depending on your DIY skills) of the cheap KeDei LCD 3.5” module (320x480 pixels), originally sold as a display option for Raspberry Pi, to simulate more standard LCD connection (seen in …
“The limited number (4) of GPIO pins on the ESP8266-01 may seem like an obstacle, for any serious application. Yet if one uses the pins in a smart way it is very well possible to do a lot with …
“In order to keep track off the temperature in the night quarters of my chicken coop I needed a wireless connection to some sensors. As I had an ESP8266-01 lying around that seemed like the perfect medium to do …
“This is my latest project – The Switcher, a Wifi, open source, power switch and socket. Built with modularity in mind – It can be mounted as a wall lights switch or used as a standalone power socket. Switcher gives the ability …
“A little over a year ago, the ESP8266 WiFi SoC started getting attention and quickly became a little chip of wonder. On a fully self-contained breakout board with this chip, a complete WiFi enabled controller is well under $5! It …
“This instructable is based on the concept of IoT. This project is going to give the real time temperature of any place. I used the Arduino Uno, lm35 temperature sensor and esp8266 wifi module. Then I am going to send …
“So I was always forgetting to water my plants, and as a result they would get dry and sometimes even die. So I though it would be cool to be able to water my plants with my phone. Its connected …
“First, use the Makerspace PCB milling machine to cut a circuit board. This was the first attempt to cut a board that uses surface mount components. Really the surface mount components are on the wrong side of the board because …
“ESP8266-01 is a great tiny little board. I’ll start by talking about my motivation for making this breakout board for the ESP 01. It’s simple, actually: I was looking at making a simple solution for flashing my …
“Man, I hate drilling holes in PCBs. I make my boards with a mill, so it shouldnt be too hard to swap the V-cutting bit for a drill bit, but I Just. Cant. Be. Arsed. And besides, I like making …