“This easy to make Drill Press Table is the perfect one day shop project! The sliding dovetail system is easier to install than t-tracks and when paired with the MICROJIG accessories this table and fence system is everything that you need for your drill press stand.
Cut List:
Everything is made from 3/4” plywood
2 - 24” x 12”
*On one section cut 3/8” deep dovetail groves at 2” and 5” off the front edge (long edge). Then cut dovetail groves at 5” off of each short edge. Optional: I cut a third vertical dovetail grove in the center of the board and stopped it at the middle point. This was for extra hold down options.
1 - 24” x 3” (Fence face) Cut a dovetail grove 1” from top edge
1 - 24” x 2 1/4” ( Fence bottom) Drill holes for dovetail hardware 5” from each edge
2 - 2 1/4” x 2 1/4” (supports)”