“The project is built for professional photo flash systems. Circuit generates high voltage from low voltage battery to operate a photo-flash tube. The project can also be used in other applications like high voltage capacitor charger, emergency strobe, high voltage power supply, security, detonators etc. LT3751 is the heart of the project.
The LT3751 is a high voltage input flyback controller designed to rapidly charge a large capacitor to a user-adjustable high target voltage set by the transformer turns ratio and three external resistors. Optionally, a feedback pin can be used to provide a low noise high voltage regulated output. The LT3751 has an integrated rail-to-rail MOSFET gate driver that allows for efficient operation down to 4.75V. A low 106mV differential current sense threshold voltage accurately limits the peak switch current. Added protection is provided via user-selectable overvoltage and under voltage lockouts for both VCC and VTRANS. This project can charge a 220μF capacitor to 300V in less than one second. The CHARGE pin is used to initiate a new charge cycle and provides ON/OFF control. The DONE pin indicates when the capacitor has reached its programmed value and the part has stopped charging. The FAULT pin indicates when the LT3751 has shut down due to either VCC or VTRANS voltage exceeding the user-programmed supply tolerances. CN1 supply input, CN2 output, CN3 have no use.”