“In continuation with my previous instructable, RC Car that you can find on this link RC Car using infrared. I’ve decided to upgrade the car with RPM measurement using Hall sensor and a neodymium magnet. In the following steps I’ll describe the parts needed for the setup and will provide the code. I did not encounter a good Instructable about RPM measurement with Hall sensor on this site so I hope it will provide valuable information for the potential readers.”
Related Content
Related Posts:
- Bike Generator Charging Station
- Irrigation System
- Tim’s Electronic Pantograph
- Tim’s Electronic Dividers - 1D
- Li-Ion battery measurement system
- Coil Winder Using Arduino
- Transparent 3D Volumetric POV
- Skate-o-Meter
- Bicycle Odometer and Speedometer with 99 Lap/Period Recorder
- Low-cost and precise rotary encoder with magnetic spheres