Other
“Make ESP RainMaker IoT Project using ESP32 to control relays with Google Assistant, Alexa, Bluetooth, IR Remote, & manual switches. In this IoT project, I have shown how to make ESP RainMaker IoT Project using ESP32 to control relays with Google …
“IR Clone is an open-source infrared remote control signal analysis and generating tool. IR Clone is an open-source IR remote control analyzer tool. This utility can analyze any IR remote control that modulates the IR signal with a 38kHz carrier …
“Driving an AC high voltage and current load using an Infrared remote is very easy with this project. This is an open-source Arduino compatible hardware that is based on ATMEGA328 microcontroller, SSR (Solid-state Relay), Infrared Receiver TSOP1838, and analog input …
“This is an 8 channel infra-red remote-control Arduino shield that can drive 8 high current loads such as LEDs, solenoids, multiple toy DC Motors, dual unipolar stepper motor, filament lamps, etc. Each channel consists of two parallel NPN transistors with …
“Hello hi everyone welcome to our new instructables as you already know from the thumbnail that in this project we’re going to make an Ir led strip controller which can be controlled using any commonly available IR remote which …
“While building a Toastmaster timer, I needed a switch to act as a Start/Stop switch. I first built it with a long flexible coax cable, but as time went on, it turned out to be impracticable: it could be …
“Hi everyone.Today i will show you how to make the simple remote testing circuit with few resistors,transistor,IR sensor,led and diode.this project can also use as the ir module for other projects like line following robot …