Other
“Raspberry Pi single board computers are wonderful devices. They can do so many things, including interact with sensors, inputs, and outputs with their GPIO (general purpose Input/Output) pins — however, analog input and output are not available on the stock …
“Frequency counter (reciprocal) Gate time selectable from 0.1 second up to 60 seconds Frequency range from 0.1 Hz up to 10 MHz (tested) Input 3.3V and 5V safe Uses a STM32F103C8 (Blue Pill) and 16x4 LCD Supplies …
“Serial (ascii) monitor with 9 lines of 28 char. Baudrate from 2400 up to 256000 baud. Digital 3.3V or 5V input. Powered by a single Lithium-Ion battery. (3.7V nominal) Supplies: ILI9341 display (here a parallel version is used …
“Now a few weeks in test and performing so well… ! An Arduino controller to very effectively keep the humidity to an acceptable level. WHY (oh why…?) Well I looked for a good solution to keep the humidity level down in …
“The new Raspberry Pi Pico offers Dual Cores and Interrupts if you use MicroPython. I thought I would give it a go and try explain some of the pitfalls to avoid. This project keeps the action running on the two …
“In this project I will show you why my new autotransformer keeps tripping my circuit breaker and how I built an AC softstarter in order to “softly” start the transformer so that it does not trip my circuit breaker. Along …
“This project is a follow up of the Illuminated Presents project that I posted earlier. My wife really liked the Illuminated Presents but kept them as Cubes and did not put a bow around it to turn them into presents …
“Why do you want to stop touching since it is part of our human nature? Well, it is all because of the virus floating around. Health officials keep telling the public to stop touching faces when they couldn’t help …
“This project is about building an adjustable high voltage generator (DC) from a low DC voltage supply. The voltage supply can range from 5V to over 25V (I use a 9V supply). Higher voltages can require heat dissipators attached to …
“Clocks are a problem for me, I keep designing them but I never seem to finish building my designs. I’m not really sure why. Maybe it’s because I limit myself to using only TTL logic, or that my …