“A rover that runs on wheels using Arduino controlled remotely through our voice command alone! (With the use of Bitvoicer).
Story
Hello Friends,
By this project we have managed to control a rover or car using our voice command alone using bitvoicer (a third party propriety software).
Contents:
Setup the Rover.
Install and configure software required.
Compile and execute the code.
SetuptheRover:
Take a base for setting up wheels for motion add two wheels that compiles up to our Reer wheels. Add a ball bearing in the front and now u get an Auto-rickshaw like structure. Place Arduino and battery on to the board and afix them with screws. Now two DC motors on two wheels and connect them to a H bridge motor driver. Connect the motor Driver to the Arduino using jumper wires.”