“The 6 Channel RF Remote Controller designed using CC2500 RF Transceiver modules and PIC16F1847 micro-controller from microchip. Transmitter provided with 6 tact switch, 4 Address Jumpers to pair multiple unit so they don’t interfere with each other. Board provided with power LED, valid transmission LED. Project works with 5 V DC, On board LM1117-3.3V regulator for CC2500 Module. Two in one PCB can be used as Transmitter & Receiver. Receiver works with 5V DC. 4 Jumper to paring RX& TX units, valid signal LED, power LED, and 9 Pin connector for outputs. Same PCB is used as transmitter and receiver. All outputs are Latch Type and TTL 5V Signal for easy interface with other devices like Relay Boards, Solid State Relays.”
Related Content
Related Posts:
- 18 PIN PIC Development Board
- Flea-Scope USB Oscilloscope (18 Msps, $13 BoM, WebUSB)
- I made a Nano USB HUB
- MicroMote: The ESP-Now Based Gesture Remote
- 433 MHz Radio Frequency Transmitter Extender/ Amplifier Modu
- Build a Self Watering System
- DIY Pomodoro PCB Watch - Boost Your Productivity!
- MIDIXCV - MIDI to Multiple Control Voltages Converter
- Scoppy Oscilloscope Math Channels Tutorial
- Solar Powered RC Buggy With Sun Tracking and Esp32-now