Other
“Open Ardbir is largely inspired by the original project formerly Braudino from Stephen Mathison and then upgraded and modified by Mike Wilson under the Mike’s Brewery appellation and is been completely reviewed by Max Nevi and Italian team (Alessio …
“This is my homemade Ball & Plate system. System consist of 2 digital servo motors (HS-422 ECO), microcontroller Arduino UNO, and 4 wire resistive touchscreen (7”). There are two PID controllers working separately for each axis. This system can move …
“Are you looking to make your own quadcopter drone or RC car with Arduino but don’t know where to start? Perhaps you already bought some 433MHz RF modules only to find out they weren’t as simple to use …
“I used Arduino Uno as a PID controller to balance a small ping-pong ball on a 4-bar mechanism. And used Matlab to plot the position of the ball vs time.”
“SAB3T is short for Servo Actuated Ball Bearing Balancing Touchscreen. A 7” resistive touchscreen is used to sense the position of a steel ball bearing. The touchscreen is mounted to a universal joint allowing it to tilt in 2 axes …
“VertiBOT is an educational project to investigate and understand sensor fusion using kalman and complementary filter algorithm and PID control in an unstable system. VertiBOT is an inverted pendulum platform that remains balanced by means of two tiny motors, located …
“Soldering irons that plug in to an AC outlet are inexpensive and convenient, but one drawback to them is that they don’t have very good temperature control. They often are either too hot or not hot enough. Some plug-in …