Main Content

A 3D printed pan and tilt assembly for your MG90S servos.

This 3D print turns your MG90S servos into a pan and tilt assembly that can be used for all sorts of things including cameras, animatronics, and whatever else you need to bring motion to!

Step One: Print the 3D Files
Print the 3D files attached to this project. I used 20% infill to ensure it was sturdy.

Step Two: Set Servos to Neutral Position
Hook up both of your servos to your Arduino controller (Uno or similar) and use the code at the bottom of this page to set your servos to the neutral position (90 degrees). This will ensure that when you mount them they’ll have the full range of motion.”

Link to article