“This project is all about controlling appliances via xBee communication in Proteus (a simulation software). Here you can see there is a GAS SENSOR and beside that there is a FLAME SENSOR (the library can be downloaded from https://www.theengineeringprojects.com/) and the xBee is connected to Arduino through Tx and Rx pins of Arduino and the lamps and the DC motor are connected to supply voltage through a relay. Each relay has one pin connected to Arduino and the other to ground. If the relay is on, then that component is connected to supply and vice versa.”
Related Content
Related Posts:
- Arduino Wireless Animatronic Hand
- Arduino
- Introducing the Nano ESP32: THAT’S I(o)T!
- UNO R4: The new dimension of making
- Arduino IDE 2.1 is now available!
- Arduino UNO R4 is a giant leap forward for an open source community of millions
- My minimal Arduino Nano board
- Portenta C33: The high-performance, low-price oxymoron
- Makers, get ready to step up your game with the GIGA R1 WiFi
- Home automation blossoms with Arduino’s Plant Watering Kit