“This instructables will guide you through the process of changing your old CNC electronics taht still use the parallel port. This can come in handy if you don’t have a computer with parallel port or do not have a converter, but even more important this conversion will allow you to control your CNC without the need for a computer or an embedded computer. Fro this we will use the Arduino Mega 2560 micro-controller and Repetier firmware with active CNC mode on.”
Related Content
Related Posts:
- Laser Engraving With DIY Arduino Scara Robot
- 4-Axis CNC Hot-wire Foam Cutter (Arduino+Ramps1.4)
- Cheap Scalable Arduino CNC (Plotter, Mill, 3D Printer…)
- Sub $200 PCB Mill that doesn’t suck!
- Single Arm SCARA Plotter - With “HOMING”
- 4AxisFoamCutter
- DIY 3D Bio-printer
- Chess Playing Robot Arm That Will Beat You!
- Zen Table
- Automated Overhead Camera Assistant for Instructional Videos