Other
“The 8 Channel Driver Arduino UNO Shield is designed to enable users to switch inductive loads for up to 800mA each channel and up to 24V DC with no heat-sink needed. It is ideal for such applications as driving 2x …
“This Arduino shield helps to drive various loads like a solenoid, valve, motor, inductive actuator, heater, and bulb. A wide supply range 8V-60V and a load current of 2.7A allows it to be used with a variety of actuators …
“This sound sensor with Relay driver shield for Arduino Nano can be used to develop sound-activated ON/OFF switch or other projects that require sound senor. LM358 op-amp is used as the amplifier, 1st op-amp amplifies the microphone signal, and …
“This small constant current LED driver Nano shield has been designed using CAT4104 IC from ON semiconductor. Its 4 channel LED driver. The board has provision to mount 20 SMD 1206 LEDs. The LED can be RED, GREEN, BLUE and …
“The Shield is an adapter allowing Arduino Nano form factor microcontrollers to be plugged into Feather form factor sockets. Hello everyone, I have a lot of time not to write anything in Hackster.io, so today I will share how …
“This is an Isolated gate driver-based N channel Mosfet Arduino Nano shield based on Si8261ACC, which can be used in various applications like DC Motor driver, solenoid driver, led driver, bulb driver and heater driver, with 3A fast switching diode …
“Current Source DAC AD5420 and Arduino UNO Hello.In this article, I would like to share my experience with the AD5420 current digital-to-analog converter, which has the following characteristics: 16-bit resolution and monotonicity Current output ranges: 4 mA to 20 …
“This project features an easy to use Digital to Analog converter (DAC) shield for Arduino Nano. The project is built using MC4725 12Bit DAC IC over I2C communication. The shield directly seats on Arduino Nano and also can be used …
“The module described here is an isolated CAN Transceiver module. This module can be used as a standalone module or as an Arduino Uno shield. A controller area network is a two-wire high-speed serial network typically used to provide data …
“This is my version of a cheap and diy arduino motor shield. It is very simple and rugged. Credit goes to Ascas for the design. Specs: Voltage = 5 - 50 V Current = 2 - 3 A Maximum two motors Speed and direction …