Content for LM311

LM311

The LM111, LM211, and LM311 devices are single high-speed voltage comparators. These devices are designed to operate from a wide range of power-supply voltages, including ±15-V supplies for operational amplifiers and 5-V supplies for logic systems. The output levels are compatible with most TTL and MOS circuits. These comparators are capable of driving lamps or relays and switching voltages up to 50 V at 50 mA. All inputs and outputs can be isolated from system ground. The outputs can drive loads referenced to ground, VCC+ or VCC−. Offset balancing and strobe capabilities are available, and the outputs can be wire-OR connected. If the strobe is low, the output is in the off state, regardless of the differential input.

Description Source

Project  Magnetic Levitation – The Digital Way

Magnetic Levitation – The Digital Way

“Magnetic-Levitation-Object with only an ESP32Pico M5Stack „ATOM LITE/MATRIX,” a modified simple 5V-relais and a Hall-sensor. Magnetic-Levitation-Object with only … an ESP32Pico M5Stack „ATOM LITE“ or „ATOM MATRIX“ a modified simple 5V-relais and a HALL-sensor A1302/A1308. The wooden carrier …

Project  BPW34 Gamma Ray Detector

BPW34 Gamma Ray Detector

“The usual approach to radiation detection is the use of a Geiger-Müller tube and its high voltage circuit requirements, but during a quick surf through the internet today, I came across this portable and “accurate looking” solution developed by Stefan …

Project  A simple 8-channel receiver voting controller for enhanced repeater coverage and usability

A simple 8-channel receiver voting controller for enhanced repeater coverage and usability

“One of the often-overlooked means of improving the coverage of an amateur radio repeater is the use of multiple receivers in a voting configuration. It’s often the case that a user can hear the repeater fine, but for whatever …

Project  Single Digit Voltmeter with LM311

Single Digit Voltmeter with LM311

“I wanted to design a logic probe as a tutorial, but there were many good ones in the web so i have tried to design a single digit voltmeter. This circuit is a design, i am unable to test it …

Project  SWP Reader Evolution

SWP Reader Evolution

“For this prototype I decided to stay with plain old through-hole packages and build the analog part in a modular way. The restriction to through-hole packages had a great influence of what parts I could use because most of the …