“BioPotential amplification on your finger tip!
BioAmp EXG Pill is a small (2.54 X 1.00 cm) and elegant Analog Front End (AFE) board for BioPotential signal acquisition that you can use with any 5v Micro Controller Unit (MCU) with an ADC. It is capable of recording publication-quality BioPotential signals like ECG, EMG, EOG, and EEG without the inclusion of any dedicated Hardware/Software filter.
BioAmp EXG Pill is very small at just 25.40 X 10.00 mm and its well-thought-out design makes it very elegant means it can be used in a variety of ways!
Pin Header Holes allow you to solder header pins (berg strip) to the BioAmp EXG Pill and by doing that you can use it on BreadBoard very easily.
Castellated Holes allow you to solder BioAmp EXG Pill directly onto your custom PCB to add BioPotential amplification capabilities.
Electrode Holes allows you to use any 1.5 mm diameter wire as electrode cable with minimal strain, thus the wire will not break easily.”