“In this Instructables, I will show you how to make a Magic cube from faulty Micro-controller.
this idea is come from when I have take Faulty ATmega2560 micro-controller from Arduino Mega 2560 and make a cube.
About Magic Cube hardware, i have make a simple circuit with mercury switch. mercury switch is ON/OFF at special angle.
Three Use of magic Cube as Anti-Stress Device, Dice and Key-chain are explain following…….
Anti-Stress Device :- Cubic shape and blinking light to attract the people.
Dice :- Blinking LED is ON at numbers 6, 5, 1 and Blinking LED is OFF at numbers 4, 3, 2.
**Key-chain:- At Center Corner of 2,3,4 numbers, Light is OFF and At Center Corner of 6,5,1 numbers, Light is ON
NOTE:- I have explained my Instructables with step by step images. if you are not understand my writing.
Supplies:
For this Project you will need………
1. Atmega128A Micro-controller (6 faulty Pieces)
2. Red/Blue blink LED ( 1 Piece)
3. 3mm Mercury Switch ( 1 Piece)
4. Button cell
5. Stainless Steel Wire 22 Gauge
6.General PCB {standard PCB thicknesses 0.062in (1.57mm)}
Instrument require to made it………
1. Soldering Iron
2. Soldering wire
3. Soldering paste
4. PCB Cutter or Heavy Scissor
5. Tweezer
6. Double side tape
7. wire cutter”