Did you decide to make an Arduino robot but worries about a lot of
wire Connections?…. Then keep reading this post. I am going to describe, how to make an easy Arduino robot without messy wire connections.

You need to make
- Arduino nano
- L293 D ic, ic base
- Capacitor – 100mf/25 v – 2pcs
- Male, female header pin
- Terminal block- 4 pcs
- Led & 1k resistor
- Hc 05 Bluetooth module
- 9 volt battery or power bank
- Any 2wd robot chassis with two 150rpm geared motor
- PCB

Link

Related Content