“This tiny module has been designed to use in Robotics, Power tools, automotive applications. The module based on MC33886 from NXP, MC33886 is a monolithic power IC comprising control logic, charge pump, gate drive, and low RDS(ON)MOSFET output H-Bridge circuitry in a small surface mount package. MC33886 is a monolithic h-Bridge ideal for fractional horsepower DC-Motor and bi-directional thrust solenoid control. The IC incorporates internal control logic, charge pump, gate drive, and low Rds. MOSFET output circuitry. The MC33886 is able to control continuous inductive DC load currents up to 5A. Output loads can be pulse width modulated (PWM) at frequencies up to 10 KHz. A Fault status output reports under-voltage, short-circuit, and over temperature conditions. Two independent inputs control the two half-bridge totem-pole outputs.”
Related Content
Related Posts:
- 4 Wheel Robot Motor Driver ( 4X 3Amps LMD18201 H-Bridge)
- 2x4 H-bridge
- 4.5A H-Bridge DC Motor Driver Module Using TB6549HQ
- DC Motor & Direction Controller with Brake using MC33035
- Arduino Transistor Motor Driver
- Half Bridge Driver based on IR2104
- Homemade Electric Screwdriver 3D Printed
- WiDC - Wi-Fi Controlled FPV Robot (with Arduino, ESP8266 and DC Motors)
- FlyPi
- Voice Control Obstacle Avoidance Arduino Robot Car