Main Content

LED Lamp

Print at your own risk. Make sure to check the scale before printing. The shade of the lamp is sized to fit 5mm leds. Battery Pack For the base of the battery pack I took a pen and cut off a section. For the caps that go into the battery pack enclosure (pen shaft) I used screw caps(commonly provided with furniture kits to hide the screws) and drilled a hole in the center. I used two of these, one for the top and one for the bottom of the battery pack enclosure. I removed the springs from the pen and cut it half. Refer to the image you’ll see I have one of the springs on the top of the battery pack. Will explain more later.”

Link to article