Other
“Chip-E is RobotGeek’s first 3D printable robot kit that you can build yourself! Powered by the RGS-13 servos and the RobotGeek Geekduino and Sensor Shield components Chip-E is a cute and lovable walking companion that you can print …
“A pegboard holder for electronic test leads and cables. This cable holder fits to the standard 1 inch spaced pegboards. The OpenSCAD file is included in case you want to modify the design.”
“I needed some drawers for organizing resistors, capacitors and other small components. I wanted the resistor compartments to have cut-outs on the dividers to make it easier to get the resistors out with fat fingers, and I wanted a lot …
“Adjust the cover tolerance so the top slides easily into the box, but is still held in place well enough. Lower tolerance = tighter fit.”
“A 3030 T-slot with customizeable length. Open in the customizer app and change the length.”
“small hinges for wide angle opening doors. Need nail or alike to engage the parts”
“Chess set built mostly of parabolas. Designed using OpenSCAD with a generic parabola function that defines a polygon based on input width and height. STL files are scaled in inches to print a pawn with a 1”x1” base and …
“This is a aouter accessory for dremel, with a guide. Two rods help to maintain the guide, while a threaded rod is used to trim the distance of the router cut. The router is screwed to the dremel.”
“Big and heavy PCB Holders are bulkier and harder to use. With this gadget i can easily do my soldering work on my table. Use M3x30 screw, nut and washer.”
“Four Whistles Version 2 is my first attempt at a “calliope” (well, sort of calliope) design utilizing the primitive knowledge I gained from the original Four Whistles Instructable (https://www.instructables.com/id/Four-Whistles/). Not being a musician and being …