“This is an easy-to-use voltage to PWM converter. The project occupies very little space. The circuit is built using the versatile silicon timing device LT6992-1 chip. Pulse Width Modulation (PWM) Controlled by Simple 0V to 1V Analog Input, multiturn trimmer potentiometer provided to adjust the duty cycle 0 to 100 %. The circuit also has provision to set the frequency to 2.65Khz, 7.8Khz, 10.7Khz or 15.7Khz using jumper J1 and J2. Circuit operates with a 5V Supply. D1 is a power LED, all connections are made easy using the 3 pin male header connector CN1. This is a very useful tool as test gear or to drive various circuits that require a PWM signal. The output frequency is very accurate and steady has 1.7% Maximum Frequency Error. CMOS Output Driver Sources/Sinks 20mA”
Related Content
Related Posts:
- 12W Constant-Current LED Driver with PWM Dimming – 12V DC@1A Input
- Creating a low-cost EV charging station with Arduino
- Explore Simple 3D Dog Robot and Multiple Servo Motor Control
- HexaClock - LED Hexagon Wall Clock
- INTEL 8051 as Arduino UNO?
- Make a simple 3D Hollow clock (Arduino Nano and 5V Stepper)
- Single Axis Joystick Controller With Arduino
- SoundBox
- TSL25911 Light Sensor
- USB Dev Board for PIC18F14k50